Tufting Academy


    Beginner
    Your Tufting Start Guide
    Tufting Techniques


H1

Tufting Gun

Overview
Setup
Operation
Maintenance
Parts ReplacementsUpgrade









Setup
Regulator Installation (Optional)
Threading
Power On
Speed Adjustement
Anncouncement
Regulator Installation (Optional)
Function of the RegulatorAdjusts the size of the threading hole, accommodating a wider variety of yarn types, plies, and thicknesses. Effectively prevents yarn from slipping off.


1. Remove the front of the gun case, and take out the screw from the needle.
2. Align the oval hole of the regulator with the screw hole on the needle.
3. Slide the regulator to adjust the size of the threading hole, ensuring it fits the thickness of the yarn.
4. Reinsert the screw from step 1 and tighten it securely.
Threading
Attention: Always turn off the machine during threading.
Yarns Suggestion: It is currently recommended to use 3 strands of 2-ply yarn, 1 strand of 8-ply milk cotton, and 2 strands of 6-ply milk cotton.


Method 1 (If the Regulator Is Not Installed)



Method 2 (If the Regulator Is Installed)


Power on
Attention: The machine should only be powered on after threading is complete.
Connect the adapter and cable, then plug the other end into the power supply port at the bottom of the tufting gun.Switch on the power located at the bottom. The indicator light ring on the back will illuminate when powered on.
Speed Adjustment
The rear rotary knob controls the tufting speed. The green LED ring indicates the current speed: a fully lit green ring represents the maximum speed of 20 stitches per second, while a quarter-lit green ring corresponds to a speed of 5 stitches per second, with increments in between, and so forth.
Suggestion: Beginners are advised to start at 3 to 4 stitches per second, roughly indicated by 1/5 of the rear LED's brightness.