H1
Heat Press Machine
Operation
Application
Important: Always perform these steps while the tufting piece remains on the frame.
Do not remove it until the adhesive has fully dried, as this could distort the design.
Do not remove it until the adhesive has fully dried, as this could distort the design.
- Evenly sprinkle TPU powder on the back of your tufting piece.
- Cover the back with silicone release paper.
Set the heat press machine to a temperature between 200-300°F and place for 30-40 seconds.
- After 40 seconds, remove the heat press machine and let it cool for about 1 minute.
- Carefully peel off the silicone release paper.
- Wait an additional 1-2 minutes for the back to cool completely.
- Trim 2cm from the Edge and Cut from the Frame.