Tufting  Academy


    Beginner
    Your Tufting Start Guide
    Tufting Techniques



Operation
Frame Setup
Fabric Setup
How to Open the leaf springs
Fabric Tensioning Operation
Fabric Removal
Fabric Extension



Anncouncement
For full assembly and operation details, please refer to here.


We’re continuously upgrading our products! Please note there are a few versions available. Most operations and assembly instructions are similar. Don’t worry if your product looks different from the video. 
Frame Setup
Rotate the knob counterclockwise to adjust the distance so that the frame is slightly wider than the thickness of the tabletop. 




Place the frame on the tabletop, then rotate the knob clockwise to fasten the frame to the table.

Fabric Setup







    Place the rod with the rolled fabric into the slot. Gently press down on both ends to secure it in the groove.



    Rotate the upper knob until the curved surface faces down and the curved rod is at the back. 




    Turn the lower knob so the movable rod points forward.







    Pull the left and right handles upward to the highest point.

    Tips: Hold one side with your hand to apply force more easily, making it simpler to pull the handle to its highest position.




    Pull the fabric off the rod and thread the edges through the gaps between the top and bottom crossbars, making sure about 7 cm hangs over the bottom.








    Open the left and right fabric-clamping leaf springs.
    Fabric Tensioning Operation
    Rotate the lower knob counterclockwise one full turn.


    Fasten the left and right springs to secure the fabric edges.



    Press down on handles(on both the left and right sides) to tighten the fabric.


    Rotate the upper knob clockwise to fully tense the fabric. We recommand about three full turns.




    Fabric Removal






    Open the left and right fabric-clamping leaf springs. (it’s easier to start from the top or bottom of the spring). 


    Press the upper unlock button and rotate the upper handwheel counterclockwise until the fabric is no longer wrapped around the crossbar. 



    Press the lower unlock button and rotate the lower handwheel clockwise until the fabric is no longer wrapped around the crossbar. 



    Pull the tufted fabric upwards to remove it.
    Fabric Extension

    After finishing one side, extend the fabric by pulling it down. Repeat the tensioning steps as done previously to ensure it is evenly stretched.