Tufting  Academy


    Beginner
    Your Tufting Start Guide
    Tufting Techniques




  H1

Tufting Frame

 Overview
Installation
Operation








Installation
Frame Parts List
Assembly Instructions

For full assembly and operation details, please refer to here.

Anncouncement
We’re continuously upgrading our products! Please note there are a few versions available. Most operations and assembly instructions are similar. Don’t worry if your product looks different from the video.


Frame Parts List




Assembly Instructions

1. Place rods A and B on a flat surface, suggesting on the floor, ensuring the bottoms are aligned. 



2. Manually rotate the internal protrusions or knobs until all four are in the correct position. Fully insert the two crossbars C assembled into the protruding side of rod A. The two crossbars are not distinguishable by top or bottom.






3. Insert the other end into rod B, but leave a 2 cm gap to ensure smooth installation in the next steps. Do not insert it fully.



4. Insert rod E (curved side up) into the upper groove of rod A, aligning the curved side with the circle of the A rod knob. Make sure rod E is fully inserted.


5. Insert crossbar D completely at the bottom.Once both crossbars are fully inserted into rod A, align and insert the other ends into rod B, ensuring the previous 2 cm gap is completely closed.



6.Rotate both knobs so that the screw holes on the rods face upward. Insert screw A into each hole and tighten it clockwise. Repeat the same steps for all four knobs.



7.Align the screws on the G components with the slots on both ends of the F rod and insert until they snap into place.